General Maintenance For The Airless Paint Sprayer

无气油漆喷涂机维护

1.Use the appropriate size歧管泵过滤器和枪过滤器for the material being sprayed

2.Check filters daily, if clogged more than 20%, replace. If punctured,立即更换。

3.每次喷洒内部堆积，裂缝，扭结，孔，水泡，擦伤以及软管盖的损坏。

4.Use two wrenches when tightening高压软管connections.

5.确保良好的气流路径进入电动机，每次使用后擦拭裹尸布。

6.在喷涂时不要用抹布或塑料盖住泵，请让良好的气流保持凉爽。

7.不要压力清洗设备。

8.Keep wet cup/brass packing nut tightened. Fill cup with TSL every time you spray to reduce paint adhesion on the rod. Do not use oil as a substitute for TSL.

9.如果在泵杆上出现了原油漆，请拧紧1/8转或哭泣的固定螺母。过度拧紧会使泵过度工作并降低性能。

10.Whenpump repair kit packingswear, paint will begin to leak down the outside of the pump. Replace pump packings at the first sign of leaking or additional damage could occur to昂贵的泵硬零件。

11.切割尖端，有几条短的水或溶剂，尖端处于“反向”位置。

12.用软刷清洁尖端。在密封的水或溶剂容器中，将短时间的提示存储。

13.更换尖端，如果风扇图案崩溃或泵无法保持足够的压力以获得良好的图案。

14.在寒冷的气候下，不要让水或油漆在内部零件或软管中冷冻。随着水的冻结，膨胀会造成严重破坏。

15.HVLP - 检查和清洁或更换进气滤器。

16. Gas Units – Check oil level. Change oil as indicated in owners manual.

17.每年在授权的DP维修中心进行一般服务检查。

18. Do a dirty rinse and a clean rinse, another rinse with clean water or thinner, with a minimum of five gallons of rinse fluid.

19.将系统用泵杆存储在下部位置。较少的空气暴露会减少腐蚀。

20.短期存储（隔夜），水还可以，较薄更好。

21.长期存储，较薄，泵装甲更好。

22. Do not store the unit under pressure.

23. To prevent fluid from running out of the sprayer during storage, fasten a plastic bag over suction tube.